Oerlikon 20 mm cannon
|Oerlikon 20 mm cannon|
A modern Oerlikon cannon (Oerlikon 20mm/85 KAA) on a Royal Navy warship
|Place of origin||Switzerland|
|Wars||World War II, various|
|Variants||Oerlikon FF, MG FF cannon|
|Shell||L70: 20×110mm RB
|Caliber||20 mm (0.787 in)|
|Barrels||Single barrel (progressive RH parabolic twist, 9 grooves)|
|Elevation||Manual training, typically able to depress to -15° and elevate to +90°|
|Traverse||Manual training, full 360°|
|Rate of fire||
L70: 820 m/s (2,700 ft/s)L85: 1,050 m/s (3,400 ft/s)
|Effective firing range||
Against low-flying aircraft (HE round)
|Maximum firing range||
HE round at 45°
The Oerlikon 20 mm cannon is a series of autocannons, based on an original German 20 mm Becker design that appeared very early in World War I. It was widely produced by Oerlikon Contraves and others, with various models employed by both Allied and Axis forces during World War II, and many versions still in use today.
During World War I, the German Reinhold Becker developed a 20 mm caliber cannon, known now as the 20 mm Becker using the Advanced Primer Ignition blowback (API blowback) method of operation. This used a 20x70 RB cartridge and had a cyclic rate of fire of 300 rpm. It was used on a limited scale as an aircraft gun on Luftstreitkräfte warplanes, and an anti-aircraft gun towards the end of that war.
Because the Treaty of Versailles banned further production of such weapons in Germany, the patents and design works were transferred in 1919 to the Swiss firm SEMAG (Seebach Maschinenbau Aktien Gesellschaft) based near Zürich. SEMAG continued development of the weapon, and in 1924 had produced the SEMAG L, a heavier weapon (43 kg) that fired more powerful 20x100RB ammunition at a slightly higher rate of fire, 350 rpm.
In 1924 SEMAG failed. The Oerlikon firm, named after the Zürich suburb where it was based, then acquired all rights to the weapon, plus the manufacturing equipment and the employees of SEMAG.
In 1927 the Oerlikon S was added to the existing product line. This fired a still larger cartridge (20x110RB) to achieve a muzzle velocity of 830 m/s (versus 490 m/s for the original Becker 20x70RB gun), at the cost of increased weight and a reduced rate of fire (280 rpm). The purpose of this development was to improve the performance of the gun as an anti-tank and anti-aircraft weapon, which required a higher muzzle velocity. An improved version known as the 1S followed in 1930.
Three sizes of gun with their different ammunition and barrel length, but very similar mechanisms, continued to be developed in parallel. In 1930 Oerlikon reconsidered the application of its gun in aircraft and introduced the AF and AL, designed to be used in flexible mounts, i.e. manually aimed by a gunner. The 15-round box magazine used by earlier versions of the gun was replaced by drum magazine holding 15 or 30 rounds.
In 1935 it made an important step by introducing a series of guns designed to be mounted in or on the wings of fighter aircraft. Designated with FF for Flügelfest meaning "wing-mounted", these weapons were again available in the three sizes, with designations FF, FFL and FFS. The FF fired a slightly larger cartridge than the AF, 20x72RB, but the major improvement in these weapons was a significant increase in rate of fire. The FF weighed 24 kg and achieved a muzzle velocity of 550 to 600 m/s with a rate of fire of 520 rpm. The FFL of 30 kg fired a projectile at a muzzle velocity of 675 m/s with a rate of fire of 500 rpm. And the FFS, which weighed 39 kg, delivered a high muzzle velocity of 830 m/s at a rate of fire of 470 rpm.
Apart from changes to the design of the guns for wing-mounting and remote control, larger drums were introduced as it would not be possible to exchange magazines in flight. For the FF series drum sizes of 45, 60, 75 and 100 rounds were available, but most users chose the 60-round drum.
The 1930s were a period of global re-armament, and a number of foreign firms took licenses for the Oerlikon family of aircraft cannon. In France, Hispano-Suiza manufactured development of the FFS as the Hispano-Suiza HS.7 and Hispano-Suiza HS.9, for installation between the cylinder banks of its V-12 engines. In Germany, Ikaria further developed the FF gun as the MG FF, firing 20x80RB ammunition. And the Imperial Japanese Navy, after evaluating all three guns, ordered developments of the FF and FFL as the Type 99-1 and Type 99-2.
The incorporation of the improvements of the FFS in a new anti-aircraft gun produced, in 1938, the Oerlikon SS. Oerlikon realized further improvements in rate of fire on the 1SS of 1942, and the 2SS of 1945 which achieved 650 rpm. However, it was the original SS gun which was widely adopted as anti-aircraft gun, being especially widely used by Allied navies during World War II.
The Oerlikon FF was installed as armament on some fighters of the 1930s, such as the Polish PZL P.24G. Locally produced derivatives of the Oerlikon cannon were used much more extensively, on aircraft, on ships and on land. In the air, the Ikaria MG FF was used as armament on a number of German aircraft, of which the most famous is the Messerschmitt Bf 109. The Japanese similarly used the Type 99 cannon on a number of types including the Mitsubishi A6M Zero.
The French firm of Hispano-Suiza was a manufacturer of aircraft engines, and it marketed the moteur-canon combination of its 12X and 12Y engines with a H.S.7 or H.S.9 cannon installed between the cylinder banks. The gun fired through the hollow propeller hub, this being elevated above the crankcase by the design of the gearing. Such armament was installed on the Morane-Saulnier M.S.406 and some other types. Similar German installations of the MG FF were not successful.
The Oerlikon became best known in its naval applications. Initially the Oerlikon was not looked upon favorably by the Royal Navy as a short-range anti-aircraft gun. All through 1937-1938 Lord Louis Mountbatten, then a Captain in the Royal Navy, waged a lone campaign within the Royal Navy to set up an unprejudiced trial for the Oerlikon 20 mm gun, but it was all in vain. It was not until the Commander-in-Chief of the Home Fleet, Admiral Sir Roger Backhouse, was appointed First Sea Lord that Mountbatten's efforts bore fruit. During the first half of 1939 a contract for 1,500 guns was placed in Switzerland. However, due to delays and then later the Fall of France in June 1940, only 109 guns reached the United Kingdom. All Oerlikon guns imported from Switzerland in 1940 were mounted on various gun carriages to serve as light AA-guns on land.
Just a few weeks before the Fall of France, the Oerlikon factory approved manufacture of their gun in the United Kingdom, under licence. The Royal Navy managed to smuggle out the necessary drawings and documents from Zürich. The production of the first British-made Oerlikon guns started in Ruislip, London, at the end of 1940. The first guns were delivered to the Royal Navy in March or April, 1941. The RAF Regiment made extensive use of Oerlikon guns in the anti-aircraft role. These were the principal armament for its Light Anti-Aircraft squadrons in North Africa, the Middle East, Italy, and North Western Europe, until the introduction of the Bofors 40/L60 40mm gun from 1943, although many squadrons retained a mix of guns until the end of World War 2. Squadrons in the Far East were equipped exclusively with Oerlikons.
The Oerlikon gun was installed aboard United States Navy ships from 1942, replacing the M2 Browning machine gun, which lacked range and firepower. It became famous in the naval anti-aircraft role, providing an effective defense at short ranges (in practice up to 1.5 km) at which heavier guns had difficulty tracking a target. The gun was eventually abandoned as a major anti-air weapon due to its lack of stopping power against heavy aircraft and against Japanese kamikaze attacks during the Pacific War. It was largely superseded by the Bofors 40 mm gun and the 3"/50 Mark 22 gun. It did, however, provide a useful increase in firepower over the .50 cal machine gun when adapted and fitted to some aircraft. However, it had some problems with jamming in the ammunition feed.
The Royal Canadian Navy popularized the use of the Oerlikon gun as an anti-ship and anti-submarine gun - while it was not effective against the armour of most larger ships, it was used extensively and effectively against U-Boats, and on the decks of larger ships. A handful of corvettes were fitted with the weapon toward the end of the war, but it appeared more commonly on frigates and destroyers at the time.
The Oerlikon was also used as the basis for the Polsten gun, designed by Polish engineers in exile in the United Kingdom. The gun went into service in 1944 and was used well into the 1950s, among other uses, on Cromwell tankscitation needed and early model Centurion tanks.
|This section needs expansion. You can help by adding to it. (October 2011)|
It is still in use today on some naval units, theoretically as a last-recourse anti-air weapon, but mainly used for firing warning shots or incapacitating small vessels.
The Oerlikon cannon and its derivatives feature blowback operation: the bolt is not locked to the breech of the gun on the moment of fire, but instead moves back freely while the propellant gases propel the projectile forward. Advanced primer ignition (API) is used so that the projectile has left the muzzle and the gas pressure in the barrel is down to a safe level before the breech opens. Whereas in simple blowback guns, the gas pressure only has to overcome the inertia of the bolt, which has stopped moving, in order to push it back and open the breech, in API operation the firing pin strikes the primer while the bolt is still traveling forward so that the gas pressure has to overcome the forward momentum of the bolt as well, to push it to the rear. This permits blowback to be used in far more powerful weapons. Nevertheless, compared to guns with a locking mechanism a fairly heavy bolt must be employed, which limits the rate of fire unless other steps are taken, as in the final version of the Japanese 99 Mark 2. To give the heavy bolt sufficient forward speed, a large spring is required, which is wrapped around the barrel of the gun. Also, the Oerlikon's chamber is longer than needed to contain the case, and the end of the bolt, which is the same diameter as the case, actually enters this extended chamber as it fires the cartridge. As a result, after firing the bolt and case must recoil a small distance to the rear before the bolt has fully re-emerged and the case in turn begins to leave the chamber. This is unnecessary in simple blowback weapons which use relatively low-power ammunition, but if a significant portion of the cartridge case of an auto-cannon emerged from the chamber, thus losing the support of the chamber walls, before the gas pressure had fallen far it would burst.
This design resulted in the use of a characteristically shaped cartridge: The case has straight sides, very little neck, and a rebated rim. The straight sides allows the case to slide back and forward in the cylindrical chamber. The neck is not supported while this happens and therefore expands when the case is fired, and the rebated rim allows the face of the bolt, with its extractor claw hooked over the rim, to fit within the chamber. To ease the motion of the case, the ammunition needed to be greased, which was a drawback of the Oerlikon cannon. An alternative developed during World War II was the so-called fluted chamber, which had grooves that allowed gun gas to seep between the chamber wall and the case, taking over the role of the grease.
Ammunition feed is typically by a 60-round drum magazine on the top of the gun. During sustained firing, the magazine must be frequently changed, reducing the effective rate of fire. Belt-fed versions of the gun were developed to overcome this limitation. A trigger in the right-hand grip controls fire. Used cartridges are ejected from below the breech.
Different nations and services operated a number of mounting types for the same basic gun. In a typical single-barrel naval version, it is free-swinging on a fixed pedestal mounting with a flat armored shield affording some protection for the crew. The cannon is aimed and fired by a gunner using, in its simplest form, a ring-and-bead sight. The gunner is attached to the weapon by a waist-belt and shoulder supports. For this reason, some mountings existed with a height-adjustment feature to compensate for different sized gunners. A "piece chief" designates targets and the feeder changes exhausted magazines.
During World War II, twin and quadruple Oerlikon mounts were developed, both for army and for navy use. The British Navy operated a hydraulically operated twin-gun mount. The US Navy operated a quad mount developed for PT boats, the Thunderbolt, which was manufactured by International Harvester. It was placed experimentally on the battleships Arkansas, Colorado, Maryland, West Virginia, Washington, Massachusetts, and training ship Wyoming.
- 20 mm modèle F2 gun
- Hispano-Suiza HS.404
- Oerlikon FF
- MG FF cannon
- Type 99 cannon
- 25 mm Hotchkiss anti-aircraft gun
- Type 96 25 mm AT/AA Gun
- 2 cm Flak 30/38/Flakvierling
- "Switzerland Oerlikon 20 mm/70 (0.79") Mark 1". NavWeaps.Com. 14 January 2011. Retrieved 24 September 2011.
- "Britain 20 mm/85 (0.79") GAM-BO1". NavWeaps.Com. 21 June 2008. Retrieved 23 October 2011.
- Anthony G. Williams, Rapid Fire, Airlife, UK 2000.
- Johnson, Melvin M., Jr. Rifles and Machine Guns William Morrow & Co. 1944 appendix
- Campbell, John. Naval Weapons of World War Two. Annapolis: Naval Institute Press, 1985.
- Johnson, Melvin M., Jr. Rifles and Machine Guns. New York: William Morrow and Co., 1944.
- Williams, Anthony G. Rapid Fire: The development of automatic cannon, heavy machine guns and their ammunition for armies, navies and air forces. Shrewsbury: Airlife Publishing LTD, 2003. ISBN 1-84037-435-7
- Pawle, Gerald (1978). Secret Weapons of World War II. New York: Ballantine Books. ISBN 0-345-27895-X.
- Heller, Daniel. Zwischen Unternehmertum, Politik und Überleben. Emil G. Bührle und die Werkzeugmaschinenfabrik Oerlikon, Bührle & Co 1924–1945. Verlag Huber: Frauenfeld 2002.
- International Harvester Corporation. "Navy Day", The Harvester World Volume 35, Number 12, December 1944; p. 12. Harvester Press, Chicago, 1944.
- Norman, Friedman (2006). The Naval Institute guide to world naval weapon systems. Naval Institute Press. pp. 478 to 480. ISBN 978-1-55750-262-9.
|Wikimedia Commons has media related to Oerlikon 20mm.|